DIY PILLOWCASE IN 3 EASY STEPS!

SUPPLIES NEEDED FOR THE PILLOWCASES:
1-yard fabric for pillowcase body – note: this is assuming that the pattern runs parallel to the selvage. If your pattern runs perpendicular to the selvage, you’ll need 1 1/4 yards. (for example, my Santa’s are running sideways across the pillow vs. standing straight up and down)
1/2 yard fabric for pillowcase band
1 1/2 yards 1″ wide ribbon for trim
Seam Tape
Thread
PILLOWCASE PATTERN CUTTING INSTRUCTIONS:
Cut:
- 1 Piece 11″ x 40″ for the pillowcase band
- 1 Piece 28″ x 40″ for the pillowcase
- Ribbon 40″ long
CONSTRUCTION STEPS:
STEP ONE:
Begin by folding the 11″ wide pillowcase band in half lengthwise. Press. Pin the 40″ side to the right side of the 40″ side of the pillowcase.

Serge this seam.

STEP TWO:
Press the seam to one side. Using the seam tape, iron the ribbon onto the pillowcase centered over the seam between the pillowcase and the band.

Topstitch Stitch ribbon very close to the edge to secure.
STEP THREE:
Fold the pillowcase in half and serge the bottom and sides.

Clip the strings and you’re done!!
Source from here
Komentar
Posting Komentar